ESC333 Simply Cinema OM 5/24/00 12:17 PM Page 14
Troubleshooting
If there is no sound fromIf there is no sound fromIf there is no sound from
any of the speakers:the surround speakers or the center speaker:
sound is very low:
Y Make sure the subwoofer isY Make sure that the processor
plugged into an active ACY Check all connectionsis in the Surround or
wall outlet.between processor/amplifier3-Stereo mode. If it is in
Y Make sure the Master Powerand each of the speakers.Phantom or Stereo mode, the
Switch, located on the rear ofY Raise the surround volumecenter speaker will not play.
the subwoofer, is in thefrom the remote control (seeY Increase the level of the
On/Standby position.Operation section).center channel, using the
Y Make sure there is a Y Make sure the TV show orlevel-adjustment instructions
source � for example, a DVDmovie you are watching isearlier in this manual.
Player, CD Player, VCR or recorded in Dolby Digital orY Check the connections
television � hooked up to onePro Logic Surround. If it isbetween the subwoofer and
of the four input jacks.not, try the Phantom orthe center speaker.
Y Make sure that the programSimulated Surround mode.If you have low bass output:
material is playing.Y Increase the surround-
Y Recheck the hookupspeakersO level, using theY Experiment with placement
connections, referring to thelevel-adjustment instructionsof the subwoofer. Remember,
Speaker Connections section.found earlier in this manual. place the subwoofer in a
corner to get maximum bass
output from the system.
Y Increase the subwoofer
level, using the level-
adjustment instructions
found earlier in this manual.
Y Increase the level of bass,
using the remote control.
-14- |