Decade Owner's Manual 9/11/98 10:26 AM Page 3
two.Speaker Connections
Connection Tips
Speakers and electronics terminals have corresponding (+) and
(�) terminals. It is important to connect both speakers identi-
cally: (+) on the speaker to (+) on the amplifier and (�) on the
speaker to (�) on the amplifier. Wiring Oout of phase� results in
thin sound, weak bass and a poor stereo image.
RIGHTLEFT
� +� +
� +� +
Speaker Outputs
Troubleshooting
If there is no sound fromIf the system plays at lowIf there is low bass output,
any of the speakers, checkvolumes but shuts off ascheck the following:
the following:volume is increased, checkY Make sure the polarities
Y Receiver/amplifier is on andthe following:(+ and �) of the left and
a source is playing.Y Check all wires and connec-right OSpeaker Inputs� are
Y Review proper operation oftions between receiver/connected properly.
your receiver/amplifier.amplifier and speakers.
Y Make sure all wires are con-
If there is no sound comingnected. Make sure none of the
from one speaker, check thespeaker wires are frayed, cut
following:or punctured.
Y Check the OBalance� controlY If more than one pair of
on your receiver/amplifier.main speakers is being used,
Y Check all wires and connec-check the minimum imped-
ance requirements of your
tions between receiver/receiver/amplifier.
amplifier and speakers.
Y Make sure all wires are
connected. Make sure none of
the speaker wires are frayed,
cut or punctured. |