CV OM 5/14/04 3:06 PM Page 5
MOUNTING OPTIONS
SATELLITES AND SURROUNDS
On shelves using the optionalOn the wall. Wall brackets areOn compatible floor stands avail-
CVTS50 table stands.included.able from other manufacturers,
using the supplied floor stand
adaptors.
ATTACHING THE CVTS50 TABLE STAND (AVAILABLE
SEPARATELY) TO THE CVSAT50
Important Safety Notes:ity (+ and � connections) by
Y The table stand consists ofplacing the positive conduc-
two main parts: a metal col-tor on the left, and the nega-
umn and a glass base. Betive conductor on the right,
extremely careful in han-looking at the front of the
dling the fragile glass baselining upstand column.
to avoid breakage thatthe holes in the base with theUse the supplied terminal
might result in personalholes in the bottom of the col-wrench to loosen the red col-
injury.umn. Screw in the bolts, mak-lar of the binding post until
Y The CVTS50 table stands ing sure the plastic washersthe pass-through hole under-
are only intended for useare between the bottom ofneath it is revealed. Insert the
with the CVSAT50 speaker.the glass base and the boltbare end of the positive wire
Attempting to use theheads. Tighten the boltsthrough the hole, then screw
stands with any other modelsecurely using a Philipsthe collar down until it is tight.
speaker is unsafe and mayscrewdriver (not supplied).Follow the same procedure
result in personal injury andDo not overtighten, as thisto connect the negative wire
damage to the equipment.might strip the threads, to its terminal. Slowly lower
Y The stands must be placedwhich is not covered by the mounting bracket on the
satellite onto the top
in a safe location, protectedthe warranty.of the metal col-
from young children andPrepare the
pets who might topple thespeaker wireumn of the CVTS50
stands, possibly resulting inas describedstand. Gently pull
the slack out of the
serious injury. Never placeon page 8.wire. Carefully
the stand so that any part ofRemove the
it is sticking out over therubber strippress the rubber
edge of the table, shelf orfrom the backstrip in place over
the wire-manage-
other surface underneath it.of the column,ment channel,
Y Do not install the CVSAT50revealing the
or any other speaker on thewire-manage-being careful to
keep the speaker
table stand in a horizontalment channel.wire in the channel
orientation, as this would beThread theand to avoid pinch-
unstable and might result intwo conduc-
personal injury.tors through the hole at theing it with the rubber strip.
top of the channel. Make sure
Carefully insert the glass base
into the slot in the column, 5to preserve the proper polar- |